Results 1 to 3 of 3

Thread: G made R1

  1. #1
    Member secsm's Avatar
    Join Date
    Apr 2013
    Location
    gettysburg
    Posts
    71
    Post Thanks / Like
    Rep Power
    5

    G made R1

    Ok guys, here is my R1 .. I stretched the rearalmost 3/8 in. to allow clearance because they want you to trim the rear dr shaft. 7 mm because of the dig unit. I used r1 upgrade dr.shaft in the rear. I stretched the front 3/16 and used CKRC heavy dr.shaft because the front would be to short . I was able to get the wheel base to 12. 3/8 in. I moved all the shocks on the frame I added more angle and relocated the rear wth all. bracket, I left it big for now to see about longer shocks. I made new body for sides and roof. I made esc mt. under the hood with alluminum. Brushless Novack Goat 3s plenty of power . One issue is not much brake, but I think it will be fine. 400 oz. servo castle bec. I am running in droop position. Hope everyone enjoys the pics.
    g1.jpgg8.jpgg9.jpgg10.jpg
    g2.jpgg7.jpg
    g3.jpgg6.jpg
    g4.jpgg5.jpg

  2. #2
    Member secsm's Avatar
    Join Date
    Apr 2013
    Location
    gettysburg
    Posts
    71
    Post Thanks / Like
    Rep Power
    5
    more R1 pics continued. One more note, the upper links were moved to the outside of the chassis. the on off switch is held on with 3 m sure lock ,it is stronger than velcro to remove insert straight screwdriver and turn. g11.jpgg12.jpgg13.jpg
    g14.jpgg15.jpg

  3. #3
    Sage member PontiacGT201's Avatar
    Join Date
    Sep 2010
    Location
    Gettysburg, PA
    Posts
    620
    Post Thanks / Like
    Rep Power
    10
    good lookin rig. with all them Rock I still gotta come over to crawl. but gotta get the scaler fixed first haha

Similar Threads

  1. made a pull pal..............
    By bob1961 in forum Scale Parts
    Replies: 8
    Last Post: 03-25-2012, 06:51 PM
  2. Made a few changes to my SCX-10
    By RickB in forum Off Road Scalers
    Replies: 10
    Last Post: 08-30-2011, 02:16 AM
  3. Parts made by the GOAT
    By CleanGOAT in forum Scale Parts
    Replies: 3
    Last Post: 07-25-2011, 02:35 AM
  4. Custom made signatures.
    By Tin Soldier in forum General Discussion
    Replies: 0
    Last Post: 02-06-2011, 05:12 PM
  5. Finally Made It
    By brazwewn in forum Introduction
    Replies: 7
    Last Post: 04-21-2010, 05:51 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •