View Full Version : Dual Fxr esc with 35t motors

11-20-2014, 08:07 PM
I got a Xr10 with dual Fxr's and 35t motors and a bec and It came with a SR300 receiver.

I have the SR300 bound to a DX4C now I am trying to program the esc's to the radio and I am having no luck until I get my mt-4

I read the instructions and still no luck

do I do one esc at a time?

I held mode down for 3 seconds until it beeped and went to 4 then held throttle and it went to 6 and held brake then it does noting.

is the a trick I missed?

I will read it again

I will first look to see if it is wired correctly
should it be like this

aux from esc do these make a difference of which goes in which aux or thr?
thr from esc
str steering servo
bnd from bec

11-20-2014, 08:37 PM
**servo to steering signal wire only**, **I run a BEC from the battery directly to the BEC to the servo red and black.**one esc with red wire pulled to the throttle the other to the aux1. From there you will need to figure out the settings on the TX. there are several ways to set it up. I am not familiar with the DX4C.

11-20-2014, 09:29 PM
I will take pics of how it is wired.i am pretty sure there is 3 wires from servo to receiver

11-23-2014, 09:34 PM
All 3 servo wires are plugged in to receiver
All 3 bec wires are plugged in to receiver
Bec is plugged in between the battery and the esc wires
Esc's have.on/off switch off each
Esc has 3 wires coming off esc's to receiver but only white and black are plugged in both red wires are cut

11-23-2014, 09:38 PM

11-23-2014, 09:40 PM

11-24-2014, 05:39 PM
I just need to change the servo as to what John said

**servo to steering signal wire only**, **I run a BEC from the battery directly to the BEC to the servo red and black.

12-18-2014, 03:53 AM
Hey man did u ever get this controler to work I'm looking for a cheap radio to work to convert my berg to dual esc how are the controls are they easy to use while crawling??

Thanx rich